Used Hilti DX350 Tools

I have sold and serviced many powder actuated tools over the last 20 years including the Hilti DX350 and the clone versions of the tool from many different manufacturers.  They are just such a solid tool with many different uses.   Here are a few points to help you find a good deal on a good used Hilti DX350.  Don’t just accept the statement that the tool fires or works well.  I have seen tools advertised as working well when they were obviously missing parts in the photos.

A Hilti DX350 tool should not just fire, it should fire solidly and advance one load each time you cycle the tool.  The most common thing a used tool may need is a piston or driver.  The piston or driver is what forces the pin into the concrete.  They are a wear part and so they chip up and can even break.  An aftermarket piston to fit the Hilti DX350 goes for around $30.  The driver is easy to replace.  If the tool isn’t advancing the load advance isn’t expensive, but it is a little more tricky to replace.   The little “C” clip that holds the front barrel together can get bent up from time to time.  Again this is a wear part, easy to replace and many of the tools have extra packed along with the tool.  Stay a way for a tool that has cracks or breaks on barrel or fastener guide.  If the tool fires and advances but make just a “poof” sound, almost like a bad load, it is likely the return pawl that reset the piston is warn.  Easy to replace but figure another $20 or so to fix.

When you are looking for a used Hilti DX350 tool you will find clone tools from Ramset, most notably the Cobra tool.  The Cobra is a great tool, but stay away from the Cobra Plus tools, many of the parts are not available.  As for prices, I have seen them all over the board but many good tools can be had for $100-$150 or so.  If you shop around you may find a tool with loads and pins to fit your application.  FYI the tool is a .27 caliber strip tool.  Loads are readily available at most big box stores.  The loads are color coded, going from the lowest, GREEN, YELLOW and then RED.  Start with the lowest power level and work up until you pin sets to correct depth.  Ramset, Simpson and Powers loads will work in the DX350 if they are .27 caliber strips.

Below are a few of the used Hilti DX350 tools available on ebay or click here for a more extensive search.

Hilti Powder Fasteners 44574/2 DX 350 19mm 3/4" Drive Pins Nails 1Box 100 Count

$7.50
End Date: Wednesday Mar-13-2019 16:56:36 PDT
Buy It Now for only: $7.50
Buy It Now | Add to watch list

HILTI DX 350 RAMSET COBRA REMINGTON 495 & 496 ANNULAR BALL & SPRING PARTS NEW

$25.00
End Date: Sunday Feb-24-2019 9:31:44 PST
Buy It Now for only: $25.00
Buy It Now | Add to watch list

Hilti DX-350 Powder Actuated Fastening Systems Nail Gun Kit With Case

$175.00
End Date: Tuesday Mar-12-2019 9:55:58 PDT
Buy It Now for only: $175.00
Buy It Now | Add to watch list

Hilti DX-350 Powder Actuated Fastening Systems Nail Gun Kit With Case

$239.95
End Date: Tuesday Feb-19-2019 9:23:43 PST
Buy It Now for only: $239.95
Buy It Now | Add to watch list

 

Bookmark the permalink.

Comments are closed